Hat problems should be paid attention to when cleaning the conventional hydraulic jack? The oil cylinder is a hydraulic actuator that converts hydraulic energy into mechanical energy and performs linear reciprocating motion (or swing motion). It has simple structure and reliable work.

When it is used to achieve reciprocating motion, the deceleration device can be eliminated, and there is no transmission gap, and the motion is stable. Therefore, it is generally used in various mechanical hydraulic systems.

You should not be unfamiliar with the application of the sync jack (Jack0). We usually need to clean it when using the device (shèbèi). So what should we pay attention to when cleaning the sync jack? Let's follow the editor to find out.

When cleaning the conventional hydraulic jack, parts that have been cleaned but not yet assembled should be stored in antirust oil. Special attention should be paid to rust prevention in humid areas and seasons. The hydraulic parts cleaning of the synchronous jacks should be carried out on the cleaning table, assuming that the conditions are restricted, the cleanliness of the temporary work table should also be ensured.

Parts cleaned by the synchronous jack cannot be wiped with cotton, linen, silk and chemical fiber fabrics to prevent the shed fiber from infecting the system. The disassembly, assembly and cleaning of hydraulic parts of the oil tank should be carried out in a clean room that meets national standards. If conditions permit, the operating room can be filled to make the indoor pressure higher than the outdoor pressure to prevent atmospheric dust pollution.