The oil cylinder is a hydraulic actuator that converts hydraulic energy into mechanical energy and performs linear reciprocating motion (or swing motion).

Hydraulic jacks are mainly used in factories, mines, transportation and other departments as vehicle repair and other lifting and supporting work. Its structure is light, firm, flexible and reliable, and can be carried and operated by one person. It has simple structure and reliable work. When it is used to achieve reciprocating motion, the deceleration device can be eliminated, and there is no transmission gap, and the motion is stable. Therefore, it is widely used in various mechanical hydraulic systems. You should not be unfamiliar with the related applications of the sync jack . We usually need to clean the device.The screw jack manufacturers in china need to strengthen technical management.

when using the device , so what should be paid attention to when cleaning the sync jack? Let's follow the editor to understand Take a moment.

When cleaning the synchronous jack, the parts that have been cleaned but not assembled should be stored in antirust oil. Special attention should be paid to rust prevention in humid areas and seasons. The synchronous jack hydraulic motor realizes continuous rotary motion, while the hydraulic cylinder realizes reciprocating motion. Hydraulic jacks are mainly used in factories, mines, transportation and other departments as vehicle repair and other lifting and supporting work.

Its structure is light, firm, flexible and reliable, and can be carried and operated by one person. The cleaning of the hydraulic parts of the synchronous jack should be carried out on the cleaning table, assuming that the conditions are limited (limit), the cleanliness of the temporary work table should be guaranteed. Synchronous jack The cleaned parts cannot be wiped with cotton, linen, silk and chemical fiber fabrics to prevent the shed fiber from infecting the system. The disassembly, assembly and cleaning of the hydraulic parts of the oil cylinder should be carried out in a clean room that meets the national standards. If conditions permit, the operating room can be filled to make the indoor pressure higher than the outdoor and prevent atmospheric dust pollution.

The synchronizing jack elbow is completed, the oil drain screw is loosened, and the plunger is automatically reset. Do not remove the quick starter when there is a load. Synchronous jacks use oil as the medium, so the oil and the machine must be cleaned and maintained to avoid blockage or oil leakage, which will affect the application effect.The screw jack manufacturers in china need to adjust their business models.

New or long-term synchronized jacks, because there is more air in the cylinder, the piston rod may have a small sudden jump during initial use. The synchronized jack can be reciprocated 2-3 times without load to eliminate the cavity Air. Jacks that have been idle for a long time will form the toughness of the seals because the seals do not work for a long time, which affects the service life of the jacks. Therefore, when the jacks are not gone, the jacks should be reciprocated 2-3 times without load every month .